Marantz VP-12S3/VP-12S3L manual Initialize the Lamp Life, Replacing Lamp Unit

❖ Initialize the Lamp Life

	The lamp has a lamp life of 2000 hours. The projector is
	designed to shut OFF power if the lamp is used beyond this
ENGLISH	2000 hours lamp life. In such case, replace the lamp and
	reset the lamp life counter as follows.
	1.	After the message “Lamp Life 0 Hours” appears, power
		to the projector shuts OFF. Promptly replace the lamp
		with a new one. (☞ P.34 “Replacing Lamp Unit”)
	2.	Once the lamp has been replaced, press the POWER
		ON button on the remote control or the POWER button
		on the projector.
		The below mesYesNewage appeLamprs on ?theNoscreen for 120 seconds.
	3.	Select “Yes”, using the 1 / 2 buttons.
	4.	Press the ENTER button. The lamp life indicator is now
		initialized.
		3.

4.

2.

STANDBY POWER ON

PATTERN 2.

PATT.

MENU V-MUTE

4.

ENTER

3.

Replacing Lamp Unit

CAUTION:

•Do not touch the lamp and the lamp unit carelessly. It is extremely hot. Wait at least one hour for the lamp to cool down before handling.

•Do not loosen any screws except for those mentioned below.

•The lamp may break if handled improperly.

•Do not use other than a Marantz replacement lamp unit.

❖How to replace the Lamp Unit

PREPARATION:

When replacing the lamp, turn off the power for the projector. After the cooling fan stops, disconnect the power cord and wait for one hour until the lamp is cooled down completely, then replace the lamp.

1.Press the STANDBY button on the remote controller or the POWER button on the projector to turn the projector off.

STANDBY POWER ON

PATTERN

PATT.

MENU V-MUTE

ENTER

2.After the cooling fan stops, Unplug the AC power cord.

3.Wait at the least one hour for the lamp and lamp unit to cool down.

4.Read the caution and warning labels on the unit.

Lamp cover

WARNING
THIS COVER IS PROVIDED WITH
INTERLOCK TO REDUCE THE RISK OF
EXCESSIVE ULTRAVIOLET RADIATION.
DO NOT DEFEAT ITS PORPOSE OR	CAUTION :	CAUTION HOT :
ATTEMPT TO SERVICE WITHOUT
REMOVING COVER COMPLETELY.
	ATTENTION :	ATTENTION CHAUD :

WARNING	CAUTION : HIGH PRESSURE LAMP	CAUTION HOT : UNPLUG
THIS COVER IS PROVIDED WITH
INTERLOCK TO REDUCE THE RISK OF	MAY EXPLODED IF IMPROPERLY HANDLED.	THE POWER CORD AND WAIT	M
EXCESSIVE ULTRAVIOLET RADIATION.	REFER SERVICING TO QUALIFIED SERVICE	60 MINUTES BEFORE CHARGING
DO NOT DEFEAT ITS PORPOSE OR
	PERSONNEL.	THE LAMP.
ATTEMPT TO SERVICE WITHOUT
REMOVING COVER COMPLETELY.	ATTENTION : LA LAMPE SOUS	ATTENTION CHAUD :
	HAUTE PRESSION PEUT SI ELLE, N'EST	DEBRANCER LE CORD ON
	PAS MANIPULEE CORRECTEMENT,	D'ALOMENTION ET ATENDER
	CONFIER L'OPERATION A UN	60 MINUTES AVANT DE
	PERSONNEL D'ENTRETIEN QUALIFIE.	CHANGER LAMPE.

34