Maxtor AVE MVDR-5000 operation manual Communication Setting, REC Enable, Timer, Sequencer, Title

on the last Sunday of March. Time reverts to standard time at 1:00 a.m. on the last Sunday on October.

SET: Sets the beginning and ending for the daylight saving time.

REC ENABLE:

This option enables/disables the programmed scheduled recording.

ON: Enables the scheduled recording.

OFF: Disables the scheduled recording.

TIMER:

This entry allows users to program the time each day when the DVR will start and stop recording. There are 2 time periods each day available for scheduling. The time is displayed in a 24-hour clock format. If there is a time overlapping showing between two continual time period settings, the device will automatically combine the two time-period settings into one.

REC SCHEDULE

START END START END

S00:00- 00:00 00:00- 00:00

M00:00- 00:00 00:00- 00:00 T 00:00- 00:00 00:00- 00:00 W 00:00- 00:00 00:00- 00:00

T 00:00- 00:00 00:00- 00:00

F00:00- 00:00 00:00- 00:00 S 00:00- 00:00 00:00- 00:00

OK CANCEL

TO MOVE TO CHANGE

SEQUENCER:

This entry allows users to set the DWELL time (time interval) for CH1, CH2, CH3, CH4, and quad view(). The valid values are 01

~99 seconds; if the dwell time is set to 00, it will disable the corresponding channels, while the sequential jumping is proceeding. In the live mode, press the Seq./Save button to switch the screen to the sequential

jumping is proceed. In live mode, press the Seq./Save button to switch the screen to the sequential jumping mode.

SEQUENCER

CHANNEL 1 2 3 4

DWELL 03 03 03 03 03

TITLE:

This entry allows users to set the titles for each video source or camera, in live or recording mode. Press the DISPLAY button to switch the display status and show the titles. The maximum length for each title is 24.

TITLE

CH1	[ FRONT DOOR	]
CH2	[ KITCHEN	]
CH3	[ BACKYARD	]
CH4	[ ROOM	]

TO MOVE TO CHANGE

4.4 COMMUNICATION Setting

MAIN MENU

RECORD

ALARM / MOTION

CLOCK/ TIMER

COMMUNICATION

DISK

SYSTEM

GOTO COMM PAGE

This option allows you to configure the status of the RS-232 / RS485 communication when connected to external devices, and the Ethernet communications settings. Please refer to sections 6.1 RS-232/RS485 Protocols and 5. Network Functions for more details.

34