MAINTENANCE
Electrical Connection
Appliances which require electrical power are equipped
with a
If an ungrounded,
outlet is encountered, it is the personal
responsibility of the appliance owner to have
receptacle replaced with a properly grounded
grounding plug is provided for protection against shock hazards. Do not cut or remove the third grounding prong from the power cord plug.
Leveling Legs
Some floors are not level. For proper baldng, your range must be level. The leveling legs are located on each corner of the base of the range. Level the range by turning the legs,
_ll[l-
((_)
Always disconnect power to appliance before servicing.
Proportional Valve Adjustment
The WARM setting should produce a stable flame when turning the knob from HIGH to WARM. The flame should be 1/8 inch or lower and must be stable on 'all ports,
To adjust: Operate burner on HIGH for about 5 minutes to preheat burner cap. Turn knob back to WARM; remove knob, and insert a slnall screwdriver into tile center of the valve stem. Adjust flame size by
turning adjustment screw in either direction. Flame must be of sufficient size to be stable on all burner
ports. If flame adjustment is needed, adjust ONLY on the WARM setting. Never adjust flame size on a higher setting.
Lift-Off Oven Door
TO remove: Open the door to the first stop position
(about 4_6 inches) and grasp the door with both hands
at each side. Do not use the door handle to lift tim door. Lift up evenly until the door dears tile hinge arms.
To replace: Grasp the door at each side, align the slots in the door with tim hinge arms and slide the door down onto the hinge arms until it is completely seated on the hinges.
Do not attempt to open or close the door until it is completely seated on the hinge arms. Do not operate the oven unless the door is in place. When baking, be sure the door is completely closed or baking results will be affected.
Light Replacement
Before replacing the oven light bulb, disconnect
power to the range. Be sure the bulb is cool Do not touch a hot bulb with a damp cloth as the bulb may break. Carefully" remove bulb. Replace with a 40 watt appliance bulb. Reconnect the power to the range and reset the clock to the current time of day.
PAGE 11
