Removing Range for Cleaning, Broiler Drawer

Open the door to the first stop position (opened about 4-6 inches) and grasp the door with both hands at each side. Do not use the door handle

to lift the door. Lift up evenly until the door dears the hinge arms.

CAUTION: The hinge arms are spring

snaps back.

Grasp the door at each side, align the slots in the door with the hinge arms and slide the door

down onto the hinge arms until it is completely seated on the hinges,

Do not attempt to open or close the door until

the door is completely seated on the hinge arms. Never turn the oven on unless the door is

properly in place. When baking, be sure the door is completely closed. Your baking results will be affected if the door is not securely closed.

Removing Range for Cleaning

When necessary, follow these procedures to

remove the appliance for cleaning or servicing:

1.Shut off the gas supply to the appliance.

2.Disconnect the electrical supply to the appliance.

3. Disconnect the gas supply tubing to the appliance.

range from the anti-tip bracket. (See the Installation Instructions for location of the

bracket.)

4. Slide the range forward to disengage the

5. Reverse the procedure to reinstall. If the gas

line has been disconnected, check for gas leaks after reconnection. (See the Installation

Instructions for the gas leak test method.)

Store a clean broiler pan and insert in the broiler drawer.

Pull the drawer out to the first stop position. Lift up the front of the drawer and pull it to the

second stop position. Grasp the sides and lift up and out to remove the drawer.

Fit the ends of the drawer glides onto the rails. Lift up the drawer front and gently push in to

the first stop position. Lift up the drawer again and continue to slide the drawer to the dosed

position.

PAGE 20