Maytag HXN4975S manual Temperature Regulation, Time to Produce 2nd & 3rd

Models: HXN4975S

1 64
Download 64 pages 29.42 Kb
Page 21
Image 21
Temperature Regulation

Temperature Regulation

Short repeated heating cycles caused by small hot water uses can cause temperatures at the point of use to exceed the thermostat setting by up to 30°F (16.7°C). If you experience this type of use you should consider using lower temperature settings to reduce scald hazards.

HOTTER WATER CAN SCALD: Water heaters are intended to produce hot water. Water heated to a temperature which will satisfy clothes washing, dish washing, and other sanitizing needs can scald and permanently injure you upon contact. Some people are more likely to be permanently injured by hot water than others. These include the elderly, children, the infirm, or physically/mentally handicapped. If anyone using hot water in your home fits into one of these groups or if there is a local code or province law requiring a certain temperature water at the hot water tap, then you must take special precautions. In addition to using the lowest possible temperature setting that satisfies your hot water needs, a means such as a mixing valve, shall be used at the hot water taps used by these people or at the water heater. Mixing valves are available at plumbing supply or hardware stores, see Figure 8 on page 9 and Figure 15 on page 13. Valves for reducing point of temperature by mixing cold and hot water are also available. Consult Maytag Customer Service (1-800-788-8899). Follow manufacturer’s instructions for installation of the valves. Before changing the factory setting on the thermostat, see Figures 22 and 23. Using the lowest hot water temperature that meets your needs will also provide the most energy efficient operation of the water heater.

Never allow small children to use a hot water tap, or to draw their own bath water. Never leave a child or handicapped person unattended in a bathtub or shower.

NOTE: A water temperature range of 120°F-140°F (49°C-60°C) is recommended by most dishwasher manufacturers.

The thermostat of this water heater has been factory set at its lowest position (PILOT LIGHTING). It is adjustable and must be reset to the desired temperature setting to reduce the risk of scald injury. The mark (Temperature) indicative of approximately 120°F (49°C) is preferred starting point. Some local codes or provinces have a requirement for a lower setting.

Turn the water temperature dial clockwise ( Time to Produce 2nd & 3rd ) to decrease

the temperature, or counterclockwise ( Manual background ) to increase the temperature.

Should overheating occur or the gas supply fail to shut off, turn off the manual gas control valve to the appliance.

FIGURE 22.

Temperature

Time to Produce 2nd & 3rd

Settings

Degree Burns on Adult Skin

VERY HOT= approx. 160°F (71°C)

About 1/2 second

C = approx. 150°F (66°C)

About 1-1/2 seconds

B = approx. 140°F (60°C)

Less than 5 seconds

A = approx. 130°F (54°C)

About 30 seconds

= approx. 120°F (49°C)

More than 5 minutes

LOW = approx. 80°F (27°C)

- - - - - - - - - - - - - - - -

 

 

FIGURE 23.

21

Page 21
Image 21
Maytag HXN4975S manual Temperature Regulation, Time to Produce 2nd & 3rd