Maytag MER6775ACB/F/N/S/W manual Oven Door Hinge, Convection Assembly, Door Plunger, Rocker Switch

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury, or death: disconnect electrical and gas supply before servicing.

Oven Door Hinge

NOTE: Removal of range from installation position is required.

1.Disconnect power before servicing.

2.Remove range from installation position, see "Move and/or Replacing Range" procedure.

3.Remove oven door, see "Oven Door(s)-Door Removal" procedure.

4.Remove smoothtop, see "Smoothtop Removal" procedure. (Perform steps 1 – 5.)

5.Remove appropriate side panel (left or right), see "Side Panel" procedure.

6.Remove screws securing hinge to front frame flange.

7.Complete hinge assembly may be removed.

8.Reverse procedure to reassemble.

NOTE: The door hinges are colored coded for ease of installation. The upper spring hook is gold and the lower spring hook is white.

Convection Assembly

(Model MER6875AA*)

1.Disconnect power before servicing.

2.Remove oven door, see "Oven Door(s)-Door Removal" procedure.

3.Remove oven racks from oven cavity.

4.From inside the oven cavity (center-rear), remove screws securing assembly shroud or ring-cover.

5.Remove screws securing assembly to cavity.

6.Remove by gently rotating assembly until enough clearance is established between assembly, cavity wall and wire terminals/connectors.

7.Disconnect and label wire terminals from heat element and assembly (connector block).

8.Remove assembly from cavity.

9.Reverse procedures to reassemble.

Door Plunger

NOTE: Removal of range from installation position is required.

1.Disconnect power before servicing.

2.Remove range from installation position, see "Move and/or Replacing Range" procedure.

3.Remove smoothtop, see "Smoothtop Removal" procedure. (Perform steps 1 – 5.)

4.Remove right side panel, see "Side Panel" procedure.

5.Label and disconnect wiring from door plunger switch.

6.Open oven door and remove screws securing door plunger to the front of the oven cavity.

7.Reverse procedures to reassemble.

Rocker Switch

1.Disconnect power before servicing.

2.Remove infinite switch control knobs located on the backguard.

3.Remove backguard, see "Oven Control/Electronic Clock" procedures. (Perform steps 1 – 4.)

4.Remove housing securing rocker switch to the backguard.

5.Label and disconnect wiring and remove switch.

6.Reverse procedures to reassemble.

Indicator Lamps

Indicator lamps include "Hot Surface" and "Element On."

1.Disconnect power before servicing.

2.Remove infinite switch control knobs located on the backguard.

3.Remove backguard, see "Oven Control/Electronic Clock" procedures. (Perform steps 1 – 4.)

4.Remove housing securing indicator lamps to the backguard.

5.Label and disconnect wiring and remove lamps.

6.Reverse procedures to reassemble.

Hi-Limit Thermostat

NOTE: Removal of range from installation position is required.

1.Disconnect power before servicing.

2.Remove range from installation position, see "Move and/or Replacing Range" procedure.

3.Remove screws securing main back shield and remove shield.

4.Remove screws securing thermostat to range main back.

5.Label and disconnect wiring and remove thermostat.

6.Reverse procedures to reassemble.

26 16023416 ©2004 Maytag Services