Maytag MER6755AAB/Q/S/W manual Oven Control/Electronic Clock, Oven Light Replacement, Oven Doors

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury, or death: disconnect electrical and gas supply before servicing.

Oven Control/Electronic Clock

1.Disconnect power before servicing.

2.Remove vent deflector by removing screws located on the underside of the backguard.

3.Remove screws securing backguard panel to backguard housing. (Screws are located on the bottom and back side of control panel.)

4.Lift backguard up, tilt forward, and lay panel on a protected surface of the smoothtop for servicing.

5.Remove screw securing mounting plate to backguard.

6.Disconnect and label wiring and remove oven control/ electronic clock.

7.Reverse procedures to reassemble.

Oven Light Replacement

The oven light used is a 120 volt, 20 watt Halogen bulb. The light automatically illuminates when the door is opened, or may be manually activated when the door is closed via the light pad. The light will not operate during a clean cycle. The oven light automatically illuminates one minute before a clock-controlled cooking operation ends.

1.Disconnect power before servicing.

2.Open oven door and locate oven light.

3.Grasp lens cover and pull outward on one side to gain access to bulb.

4.Carefully remove old bulb by lifting bulb out of ceramic base.

NOTE: To avoid damaging the new bulb and decreasing life of the bulb, do not touch new bulb with bare hands or fingers.

Hold with a cloth or paper towel.

5. Reverse procedures to reassemble.

Bulb

Socket

Lens

Bulb specifications:

G5.3 Type Halogen Bi-Pin 120 volt, 20 watt

Oven Door(s)

Do not place excessive weight on an open oven door or stand on an opened door as, in some cases, the range may tip over, break, or cause serious injury.

Both the upper and lower oven doors are removable.

NOTE: DO NOT LIFT OVEN DOOR USING HANDLE. Damage to the oven door and personal injury may occur.

Door Removal

•Open door to stop position (approximately 4"), then grasp both sides of the door and lift up off hinges.

•Lay door on a protected surface, liner side up.

•Close door hinges completely to avoid personal injury.

Door Replacement

1.Open door hinges to first stop position and align slots on the door with the hinge arms on the range.

2.Slide door downward onto hinge arms until the door is completely seated on the hinges. Push down on the top corners of the door to completely seat door on hinges. Door should not appear crooked.

NOTE: The oven door on a new range may feel “spongy” when closed. This is normal and will decrease with use.

Gasket and Door Disassembly

NOTE: Door gasket can be replaced by removing door insert clips and sliding gasket out of bottom door insert.

1.Remove oven door, see "Oven Door(s)-Door Removal" procedure.

2.Remove screws securing doorframe to liner located at the bottom.

3.Remove side screws securing doorframe to door liner.

4.Remove screws securing door trim at the top.

5.Slide doorframe and glass off liner from the bottom.

6.Remove screws securing door handle to door liner. (Two on the sides and two in front.)

7.Remove screws securing door baffle to liner.

8.Remove screws securing door baffle to window pack.

9.Remove door baffle and insulation wrap.

10.Remove screws securing window pack to liner. (Window pack comes out as an assembly.)

©2004 Maytag Services 16023416 23