Maytag UMV1152CA manual Light Socket Removal, Grille Heater Element Removal Select Models

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power to microwave oven and discharge the high voltage capacitor before performing any disassembly procedures.

Convection Motor and Heater Element Removal (Select Models)

1.Disconnect power to oven.

2.Discharge high voltage capacitor, see "High Voltage Capacitor Removal" procedure.

3.Remove outer case, see "Outer Case Removal" procedure.

4.Remove screws securing back cover and pull the top of back cover downward, sliding right side metal tab from oven cavity.

5.Remove screws securing air duct to chassis and other components.

6.Label and disconnect wire leads from air duct.

7.Remove magnetron see "Magnetron Removal" procedure.

8.Remove screws securing bottom plate to chassis.

9.Disconnect wire leads from convection chamber.

10.Remove screws securing convection chamber assembly and lift assembly from oven cavity.

11.Slide inner convection fan blade off convection motor shaft.

12.Remove nuts securing convection motor to bracket.

13.Replace and reassembly in reverse order.

Light Socket Removal

1.Disconnect power to oven.

2.Remove Grille, see "Grille Removal" procedure.

3.Remove screws securing bulb holder.

4.Remove light bulb and socket.

5.Disconnect wire terminal plug.

6.Replace and reassemble in reverse order.

Grille Heater Element Removal (Select Models)

1.Disconnect power to oven.

2.Discharge high voltage capacitor, see "High Voltage Capacitor Removal" procedure.

3.Remove outer case, see "Outer Case Removal" procedure.

4.Remove screws securing back cover and pull the top of back cover downward sliding metal tab on right side from oven cavity.

5.Remove screws securing air duct to chassis and other components.

6.Disconnect wire leads from air duct.

7.Remove screw securing upper insulator.

8.Remove screws securing the heater terminal and heater barrier.

9.Remove screws securing the heater holding bracket.

10.Remove grille heater from cavity.

11.Replace and reassembly in reverse order.

Convection Heater Element Removal (Select Models)

1.See “Convection Motor Removal;" perform steps 1 through 9.

2.Remove screws at and next to terminals securing wires and element to heater box.

3.Release metal clip securing element to heater box.

4.Remove element from heater box.

5.Replace and reassembly in reverse order.

38 16027303 © 2006 Maytag Services