Maytag UMV1152CA manual D.Aligning The Wall Plate, Installation Instructions

Installation Instructions

Installation Instructions

D.ALIGNING THE WALL PLATE

Hole A	Centerline
	notches

Horizontal Line Area E

Draw a Vertical Line on Wall from Center of Top Cabinet

C

L

Hole C Hole B Horizontal Line

Draw a Horizontal line on wall from bottom of “Rear Wall Template”.

CAUTION: Wear gloves to avoid cutting fingers on sharp edges.

1.Draw a Vertical line on the wall at the center of the 30" wide space.

2.Draw a Horizontal line on the wall at the bottom of “Rear Wall Template”.

3.Drill 5/8" holes for toggle bolts on 3 locations (Hole A, Hole B, Hole C) but if the location of hole is same as that of stud, drill a 3/16" hole for wood screw. In other words, toggle bolt can not be used to the location of stud.

NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.

NOTE: Holes A, B and C are inside area E. If none of A, B and C is in a stud, find a stud somewhere in area E and draw a forth circle to line up with the stud. It is important to use at least one wood screw mounted firmly in a stud to support the weight of the microwave. Set the mounting plate aside.

10

© 2006 Maytag Services 16027303 A – 11