Maytag UMV1152CA manual C5.MOUNT THE MICROWAVE OVEN, Installation Instructions

Installation Instructions

Installation Instructions

6.Place the blower unit back into the opening.

AFTER: Fan Blade

Openings Facing Back

End A

End B

CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched.

NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave oven.

7.Secure the blower unit to the microwave with the screw.

Blower-Plate

Back of	From the Mounting
	Plate screw
Microwave

8.Attach the exhaust adaptor to the rear of the oven by sliding it into the guides at the top center of the back of the oven.

	Adaptor
	Back of
	Microwave
	Guide
Guide	From Blower motor screw
	(after attached the exhaust adaptor)

Push in securely until it is in the lower locking tabs. Take care to assure that the damper hinge is installed so that it is at the top and that the damper swings freely.

C5. MOUNT THE MICROWAVE OVEN

FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN.

IMPORTANT: Do not grip or use handle during installation.

NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.

NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws.

NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1–3. Do not pinch cord or lift oven by pulling cord.

1.Lift microwave, tilt it

forward, and hook slots at back bottom edge

onto four lower tabs of mounting plate.

2.Rotate front of oven

up against cabinet bottom

3.Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely

tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet.

20

© 2006 Maytag Services 16027303 A – 21