Garmin DTC300 manual Installing Blank Cards into the Card Hopper, Step

RESTRICTED USE ONLY Fargo Electronics, Inc.

Installing Blank Cards into the Card Hopper

The Fargo DTC400/DTC300/DTC300M Printer is capable of printing single load cards and multiple feed cards (batch mode).

•To print using single feed, simply remove all cards from the Card Hopper, leave the Card Hopper door closed and place a card in the single Feed Card Slot (which can be used repeatedly).

•Again, the cards should be loaded with the print side down and (if applicable) the magnetic strip up and towards the front of the Printer.

To print using Batch mode follow the instructions below.

Step Procedure

1Open the Card Hopper Cover.

2Press the Card Hopper Load Lever down until the Card Tray locks into place, as shown in Display B in this section.

3Load up to 100 cards into the Hopper with the print side down.

If using cards with a magnetic strip, the magnetic strip should be loaded with the strip up and to the front of the Printer, as shown in Display C in this section.

4Close the Card Hopper Cover to release the Card Tray.

Continued on the next page

Display A – This is a graphics showing how to insert the cards.

DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 3-11