Garmin DTC300 manual Running the Self Test

RESTRICTED USE ONLY Fargo Electronics, Inc.

Running the Self Test

Perform a self-test after (a) an initial setup of the Printer, (b) a calibration procedure has been conducted, or (c) a part has been replaced to check for proper Printer operation.

Step	Procedure
1	Verify that a full-color or Premium Resin Ribbon Cartridge is installed and that
	cards are properly loaded.
	Caution: If the power is ON, disconnect the Power Cable from the
	Printer’s rear panel.
2	Press and hold the Pause/Resume button.
3	While holding down the Pause/Resume button, plug the power cable back into the
	Printer.
4	• Full Color Ribbon Cartridge installed: The Printer will print a 3-color process
	gray scale on the front of the card. The overlay pass is not printed during the
	Self-test. (See Display A below)
	• Premium Resin Ribbon Cartridge installed: The Printer will print a single color
	gray scale on the front of the card. See Display B below)

DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 4-51