Garmin DTC300 manual Running the Magnetic Self Test HiCo Only

RESTRICTED USE ONLY Fargo Electronics, Inc.

Running the Magnetic Self Test (HiCo Only)

Perform a self-test after (a) an initial setup of the Printer, (b) a calibration procedure has been conducted, or (c) a part has been replaced to check for proper Printer operation.

Step Procedure

1Remove Ribbon Cartridge from the Printer and close the front cover

Caution: If the power is ON, disconnect the Power Cable from the Printer’s rear panel.

2Press and hold the Pause/Resume button.

3While holding down the Pause/Resume button, plug the power cable back into the Printer.

4The Printer will Encode magnetic information on all 3 magnetic tracks

DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 4-53