Garmin DTC300 manual Using the Print End of Form Option, Rear of Printer

RESTRICTED USE ONLY Fargo Electronics, Inc.

Using the Print End of Form Option

Use this option to reduce or increase the overall printable area in order to optimize edge-to- edge printing toward the trailing edge of a card. (Note: When adjusting this value, keep in mind that cards always remain in the same position while moving through the Printer.)

The diagram (below) represents how the end of form will move in relation to the fixed card position as a positive or negative Print End of Form value is entered.

Step Procedure

1Enter a negative value to reduce the Print End of Form and move the end of the printable area more toward the leading edge of the card.

OR

Enter a positive value to increase the print length and move the end of the printable area more toward the trailing edge of the card.

•Maximum Adjustment Range: The maximum adjustment range is ±127. As a rule, 10 equals about .030"/. 8mm, which is about the same as the thickness of a standard CR-80 size card.)

Rear of Printer

	-
Card Output	Card Input
Side of Printer	Side of Printer
(Leading Edge	(Trailing Edge
of Card)	of Card)
	Direction card travels through printer
	Front of Printer

DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 5-90