Garmin manual Reviewing the DTC400/DTC300/DTC300M Sequence of Operations, Step Process

RESTRICTED USE ONLY Fargo Electronics, Inc.

Reviewing the DTC400/DTC300/DTC300M Sequence of Operations

The following sequence describes a full color print job with magnetic encoding.

Step Process

1The File information is received from the PC

2Printer checks the installed Ribbon type stored in memory against the Ribbon type command that was sent from the Printer.

a. If Ribbon type does not match, the media light will begin flashing.

3The Card Input Motor and Print Stepper Motor engage.

4The Card Feed Sensor detects leading edge of card and disengages the card input Motor.

Continued on the next page

DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 1-4