Garmin DTC300 manual Resolving a No Mag Installed Error, Step Procedure

RESTRICTED USE ONLYFargo Electronics, Inc.

Resolving a No Mag Installed Error (continued)

Step Procedure

2Press the Cancel Print button on the Driver Monitor Error Display Message.

3Reboot the Printer by cycling the power.

4Verify that the Printer has a Magnetic Encoder installed.

a.Open the front cover.

b.Remove the Magnetic Module cover screw.

c.Remove the Magnetic Module cover.

d.Verify that the Printer has a Magnetic Module installed. (Note: If the Printer is equipped with a Magnetic Encoder Module, ensure that it is seated securely into the Magnetic Module docking station. If the issue persists, replace the Magnetic Module. See the DTC400/DTC300/DTC300M User Guide for replacement procedures.)

5If the Printer has no Magnetic Encoder module, verify that the encoding data was sent in error, check the appropriate software user’s manual for encoding instructions.

DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 4-18