RESTRICTED USE ONLY

Fargo Electronics, Inc.

Using the Magnetic Encoder Voltage Offset Option

Use this option to adjust the voltage of the Magnetic Encoder.

Encoder voltage is set from the factory at a default of 7.24vdc for Hi-Co Magnetic cards and 2.54vdc for Lo-Co Magnetic cards.

Depending on the cards that are being used, it may be necessary to adjust the encoder voltage out of default.

See the next two procedures for instructions on adjusting the Magnetic Encoder Voltage.

(Note: The required encoder voltage for the cards will need to be known in order to properly set the Encoder Voltage Offset value. This information should be available through the card manufacturer or reseller).

DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1)

5-92

Page 202
Image 202
Garmin DTC300 manual Using the Magnetic Encoder Voltage Offset Option