Maytag UMV1152CA Turntable Motor Removal, Vent Blower Removal, Disassembly Procedures, Blower ASM

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power to microwave oven and discharge the high voltage capacitor before performing any disassembly procedures.

Turntable Motor Removal

1.Disconnect power to oven.

2.Remove screws securing bottom plate cover.

3.Open the oven door, remove turntable, and gently pry upward on turntable shaft.

4.Disconnect wire leads from turntable motor.

5.Remove screws securing turntable to the oven cavity.

6.Replace and reassemble in reverse order.

Vent Blower Removal

Vent blower is a five speed capacitor run blower assembly located on top of the oven. The blower is operated by voltage relays located on the circuit board.

Vent Exhaust Blower Removal

1.Disconnect power to unit and remove unit from its installation.

2.Remove screws securing damper and motor assembly to top and back of unit.

3.Remove damper.

4.Lift blower assembly out and disconnect wire connection wire terminal.

5.Reassemble in reverse order.

NOTE: Place blower assembly wires in slotted area to avoid pinching of wires.

Damper ASM

Blower ASM

© 2006 Maytag Services 16027303 37