McIntosh MS300 user manual Connecting Pioneer CD/DVD Changers CDs Only

Manual	MUSIC ON THE MS300
MS300 User’s

and the MS300.

•To control power on and power off for the Kenwood changer you must connect the 1/8” male to male cable between the “S-Link/IR Out” jack on the MS300 and the “DVD CONTROL” jack on the Kenwood changer.

Connecting Pioneer CD/DVD Changers (CDs Only)

The MS300 requires that you connect each changer to the back panel using audio and control cables.

Follow these steps to connect your Pioneer DV-F07 changers to your MS300:

1.A custom RS-232 serial cable with 9 pin and 15 pin connectors is required to connect the DV-F07 changer to the MS300. These can be purchased from your McIntosh Dealer.

2.Connect one end of the RS-232 serial cable into Communication Port number 1, on the back of your MS300.

3.Connect the other end of the RS-232 serial cable into the “Interface Connector” port on the back of your changer.

4.Locate the stereo RCA audio patch cable.

5.Connect one end of the RCA audio cable into the Analog In jacks number 1 on the back of your MS300

6.Connect the other end of the RCA audio cable into the Analog Audio Out jacks on the back of your changer.

• If you have more than one changer, repeat these steps to connect the additional changers to communications

PAGE 24