System Settings
and select the device on the Touch- button that you wish to teach into.
4.Place your original remote control to the UR12 head to head about
5.Press either the Device
6.Press the button on your original re- mote control that you wish to teach into the UR12. The UR12 will “beep” indicating that it received the signal and the
7.Press the same button on the original remote control a second time to ensure correct learning. The UR12 will beep a second time with “GOOD” flashed on the Touch Screen, indicating that it learned the code correctly. If it flashes “FAIL”, repeat from Step 5 until it learns successfully.
8.Move on to the next button (or device) you wish to teach by repeating from Step 5. If you are teaching functional buttons, you can also move on to teach
the buttons in the next page by press- ing the PAGE button.
9.Once you complete the teaching and wish to exit from the leaning mode, press the MAIN button to go back to the main page of the learning mode. Exit from the Main page by pressing both the MAIN and PAGE buttons si-
multaneously.
10.You will be in the setting mode once again. Move the cursor to 8. TO EXIT and press down the cursor or simply press the MAIN button to exit to the main menu.
Erasing the Learned Buttons
Erase a single button
1.Go to the program setting mode by pressing both the MAIN and PAGE buttons simultaneously for five sec- onds.
2.Move the cursor to 4. LEARNING with the joystick and then push the joystick down to enter the learning mode.
3.Move the cursor to COMMON BUT- TON and select the device that con- tains the functional button you wish to erase. If you wish to erase the function
2 - 3 inches (5.08 - 7.62 cm) apart
Other Brand Remote | McIntosh UR12 |
| Figure 14 |
21
