Customising 518 using Config | 28 |
|
|
3.Use the 
and 
Volume keys until the correct logo is indicated – see the list above.
4.Make changes for all the source options.
Note If you select the logo ‘N’ the 518 will ignore that key on the Remote control and that source will not be offered in the Normal source menu.
Changing the input for a source
In Config mode:
1. Press Source until you see a
CD CD
2.Press Source until the Remote key name for the source you wish to configure is displayed.
3.Press DSP.
you should see the display change to one like:
CD D1
The Remote control key you are setting up is the source name and it is indicated on the left as before. Now the letters on the right indicate which of the four physical input connectors will be selected.
To change the physical inputs:
1.Use the 
and 
Volume keys until the correct one is indicated
2.Make changes for all the source options by pressing Source.
Note When customisation is complete, switch the power off and then on again to restore Normal mode and to save what you have done.
Choosing the Comms type for a source product
This setting currently only applies to a source which is a Meridian CD player or Radio tuner.
In Config mode:
1. Press Source until you see a
CD CD
2.Press Source until the Remote key name for the source you wish to configure is displayed.
3.Press DSP until you see a display like:
CD 1C
4. Use the 
and 
Volume keys to chose the Comms type.
CD players are always 1C, tuners are always 2C. NC means the source is not Meridian.
5. Make changes for all the source options by pressing Source.
Choosing the address of a source product
In Config mode:
1. Press DSP until you see a display like:
CD 1A
2.Use the 
and 
Volume keys to choose the product address
3.Make changes for all the source options by pressing Source.
518 User Guide
