MGE UPS Systems 30A specs

2. Installation

Upsilon STS 30 to 250 A	Input:	3 phases + PEN
	Output:	3 phases + PE

See section 1.3 for information on accessing the connections.

Connections are made using lugs connected to threaded studs (diameter 8 mm).

The cables are tied to the earth bar.

N L1 L2 L3

N L1 L2 L3N L1 L2 L3

	N
PEN	PE	PEN
		275 mm
	S1	S2

Upsilon STS 30 to 250 A Input: 3 phases + PE + Neutral Output: 3 phases + PE + Neutral

See section 1.3 for information on accessing the connections.

Connections are made using lugs connected to threaded studs (diameter 8 mm).

The cables are tied to the earth bar.

N L1 L2 L3

N L1 L2 L3N L1 L2 L3

NNN

PE PE PE

275 mm

S1

S2

Upsilon STS 30 to 250 A	Input: 3 phases + PE
	Output: 3 phases + PE

See section 1.3 for information on accessing the connections.

Connections are made using lugs connected to threaded studs (diameter 8 mm).

The cables are tied to the earth bar.

N L1 L2 L3

N L1 L2 L3N L1 L2 L3

PE PE PE

275 mm

S1

S2

34020113EN/AA - Page 13

Image 13

MGE UPS Systems 30A user manual Upsilon STS 30 to 250 a Input Phases + PEN Output

Contents

Upsilon STS 2 34020113EN/AA Introduction Foreword Using this documentPictograms Document Contents Appendix Upsilon STS 30 60 100 160 250 a cabinet 1400 mm high Presentation Upsilon STS 30 60 100 160 250 a cabinet 1400 mm high Access to control and connections Function buttons Man / machine interface JBus communication card Relay communication cardOutput terminal block Positioning Installation Power connections Upsilon STS 30 to 250 a Input Phases + PEN Output L1 L2 L3 Upsilon STS 400 to 600 a Input Phases + PEN Output Connection of the emergency power off terminal block Connection of the Jbus communication card Connection of the communication cardsRS232 RS485 Characteristics of the input contacts Characteristics of the output contactsConnection of the relay communication card Operation Load is not supplied with powerStart-up Shutdown Operation on the preferred source Normal mode. Operation on preferred source S1Automatic transfer to the alternate source Manual transfer to the alternate source Manual transfer to an out-of-phase alternate source Main screen Display screens Upsilon STS customization Factory setting Customization Signals available on each contact Inputs Factory settingCustomization of the relay communication card Identification of anomalies MaintenanceTransfer to the manual bypass Environment UPS recycling at the end of service life Appendix Upsilon STS simplified diagram Simplified diagramsSimplified diagram of an installation Glossary Connections Index