Personalization, Function | MGE UPS Systems 6 kVA, 4.5 kVA, 9 kVA

3. Operation

3.5 Personalization

Function

Personalization parameters can be set and modified using the "UPS Driver" software installed on a computer that is connected to the UPS (see section 2.3 Connection to the RS 232 communications port).

Check that the RS 232 cable 22 is correctly connected and that the battery circuit breaker 2 is closed.

"UPS Driver" installation:

1 - Insert the Solution-PacCD-ROM containing the UPS Driver software in the drive of a PC running Windows.

2 - Open the Windows File manager or Explorer and select the CD-ROM drive.

3 - Double-click "\Emb\Index.htm", then "UPS Driver".

Once "UPS Driver" has been installed, UPS parameters can be modified in a window containing a number of tabs, each presenting a set of parameters.

"ON / OFF conditions" tab

Personalizable function	Default setting

Automatic start	Enabled

Cold start (battery power)	Enabled

Forced shutdown	Enabled

Sleep mode	Disabled

UPS ON / OFF via software	Enabled

51033212EN/AC - Page 21

Image 21

MGE UPS Systems 6 kVA, 4.5 kVA Personalization, Function, On / OFF conditions tab, Personalizable function Default setting

Contents

Comet EXtreme Installation Introduction Using this document ForewordPictograms Contents Glossary Index Failure of AC input power and operation on battery power Comet EXtreme range Presentation6 kVA tower models 6 kVA rack models 12 kVA tower models 12 kVA rack models Back Comet EXtreme 4.5 and 6 kVAComet EXtreme 9 and 12 kVA Battery extensions for UPS backup times of 80 minutes EPO Emergency Power OffBattery extensions for 4.5 or 6 kVA Comet EXtreme Options CLA Battery extensions for 9 or 12 kVA Comet EXtreme Control panel Alarms Battery Load Remaining Installation Electronic module Battery moduleUnpacking and checks Electronic module Rack mounting diagram with rails Installation of the rack version Check that the battery circuit breaker 2 is OFF Battery-module connections Connection to the RS 232 communications port optional Installation of the communications-card option Connection to the connection modules Always connect the earthing wire first Operation ON-LINE operating mode When button 15 is pressed Start-upBargraph indications Failure of AC input power and operation on battery power Personalization Personalizable function Default settingFunction On / OFF conditions tab Personalizable function Default setting Options Battery tabOutput tab By-pass tab Shutdown Connected equipment is no longer supplied with power Troubleshooting MaintenanceFrench Training Center on Montbonnot site USA Training Center on Costa Mesa site Maintenance Disconnecting the connection module Replacement of the electronic module Connected equipment is again protected by the UPS Reconnecting the connection module Environment UPS recycling at the end of service lifeThis product has been designed to respect the environment Packing Appendices ON-LINE modeGlossary Manual bypass Start on battery power Sleep modeTolerance for AC-power Out of tolerance UPS Driver Index 32 51033212EN/AC