Installation | MGE UPS Systems 5000 RT manual

Installation

2.1Unpacking and Contents Check

UPS Module Contents (87050)

46

47	option
	option
	(66102)

Optional Transformer Module Contents (87102)

51

54

49

43

45

Step down transformer is designed to provide isolated 120 volts AC outlets.

Optional Battery Module Contents (87103)

51

52

54

50

53	53

43

(40)Pulsar MX 5000 UPS

(41)Two sets of tower stands

(42)RS232 communications cable

(43)Product documentation

(45)Telescopic rails for rack enclosure with mounting hardware

(46)Screw driver

(47)Solution-Pac power management suite CD-ROM

(48)Network Management card (optional)

(49)Transformer 5000

(50)Pulsar MX EXB RT battery module

(51)Tower stand expanders

(52)Battery cable

(53)Battery communication cable

(54)Stabilizer bracket (4 screws included)

	Please see the appropriate manual for packing contents of the optional battery module and transformer module.
i	Packaging must be destroyed according to waste management standards. Recycling icons are displayed for easy selection.
	A dangerous voltage is present inside the power module and the battery module. Any operations to be
	carried out on these modules must be done so by qualified personnel.

86-87050-00 A01

Installation

2 — 1

Image 15

MGE UPS Systems 5000 RT user manual Installation, Unpacking and Contents Check

Contents

Pulsar MX Page Pulsar MX Pulsar MX Contents Return Policy for Repair of Single Phase Products RGA Technical Support and Product Services Environmental protection Introduction Important Safety Instructions Symbol Usage This page left blank intentionally 86-87050-00 A01 Rack Position PresentationStandard Positions Tower Position Pulsar MX 5000 RT Pulsar MX EXB RT Transformer Rear Panels Accessories for Rack Mount Display and Control PanelRack Mounting Kit Battery extensions for Pulsar MX RT Extended Battery EXBBattery Integration System Kit with Casters Optional battery extension cable 6 ft/1.8 m Unpacking and Contents Check Installation Installation in Tower Position Internal Battery Connection Battery Start-up To adjust the display position Installation in Rack Position Rear bracket system included with rail kits Communication Ports Connection to the RS232 or USB communication portConnection to the communication port by relays Recommended upstream protection Remote Power Off communication portInstallation of optional Communication card Required Protective Devices and Cable Cross-Sections Always connect the ground wire first Hardwire Connection of Output Power Cable to UPS Connection to Output Receptacles Connection of Extended Battery Module, UPS, and Transformer UPS Set-Up OperationInitial Start-Up Final Start-Up Sequence Operating Modes Normal modeECO mode Equipment is supplied in ECO mode End of backup time Operation on Battery PowerTransfer to battery power Low battery warning UPS Shutdown When AC Present UPS Shutdown When on BatteryReturn to Normal AC Source Access to Maintenance and Personalization Data Access to MeasurementsDisplay Organization UPS Set-Up Local SettingsOutput Settings ON/OFF Settings Maintenance UPS Set-Up Using External SoftwareBattery Settings This page left blank intentionally 86-87050-00 A01 Displayed details Signification Correction TroubleshootingTroubleshooting Leds 21 Equipment is no longer protected by the UPS Display Signification Correction Power Module Fault LCM warning details Signification Life Cycle Monitoring LCMDescription Get free offers Reset or disable LCM Secure your installation power continuity Disconnecting the battery sub-module MaintenanceHot Swapping the Power Sub-Module Hot Swapping the Battery Sub-Module 86-87050-00 A01 Appendix Technical specifications MGE Standard Single Phrase Warranty Technical Support and Product Services Pulsar MX Glossary Pulsar MX Page Scenic Avenue, Costa Mesa, California 92626 714 Contact MGE