MGE UPS Systems 5000 RT specs

Pulsar MX

Do not install the UPS or battery module in hermetic closed environments without any exchange of air.

Follow steps 1 to 4 for rack mounting the UPS onto the rails.

The rails and the necessary mounting hardware are supplied by MGE UPS SYSTEMS.

Note for step 1: It is possible to adjust the position of both front mounting brackets.

Rear bracket system (included with rail kits)

To be used if you need to move the rack enclosure with UPS already rack-mounted inside.

2 — 4

Installation

86-87050-00 A01

Image 18

MGE UPS Systems 5000 RT user manual Rear bracket system included with rail kits

Contents

Pulsar MX Page Pulsar MX Pulsar MX Contents Technical Support and Product Services Return Policy for Repair of Single Phase Products RGA Introduction Environmental protection Important Safety Instructions Symbol Usage This page left blank intentionally 86-87050-00 A01 Tower Position PresentationStandard Positions Rack Position Rear Panels Pulsar MX 5000 RT Pulsar MX EXB RT Transformer Accessories for Rack Mount Display and Control PanelRack Mounting Kit Optional battery extension cable 6 ft/1.8 m Extended Battery EXBBattery Integration System Kit with Casters Battery extensions for Pulsar MX RT Installation Unpacking and Contents Check Internal Battery Connection Battery Start-up Installation in Tower Position Installation in Rack Position To adjust the display position Rear bracket system included with rail kits Communication Ports Connection to the RS232 or USB communication portConnection to the communication port by relays Required Protective Devices and Cable Cross-Sections Remote Power Off communication portInstallation of optional Communication card Recommended upstream protection Hardwire Connection of Output Power Cable to UPS Always connect the ground wire first Connection of Extended Battery Module, UPS, and Transformer Connection to Output Receptacles Final Start-Up Sequence OperationInitial Start-Up UPS Set-Up Equipment is supplied in ECO mode Normal modeECO mode Operating Modes Low battery warning Operation on Battery PowerTransfer to battery power End of backup time UPS Shutdown When AC Present UPS Shutdown When on BatteryReturn to Normal AC Source Access to Maintenance and Personalization Data Access to MeasurementsDisplay Organization ON/OFF Settings Local SettingsOutput Settings UPS Set-Up Maintenance UPS Set-Up Using External SoftwareBattery Settings This page left blank intentionally 86-87050-00 A01 Equipment is no longer protected by the UPS TroubleshootingTroubleshooting Leds 21 Displayed details Signification Correction Power Module Fault Display Signification Correction Get free offers Life Cycle Monitoring LCMDescription LCM warning details Signification Secure your installation power continuity Reset or disable LCM Hot Swapping the Battery Sub-Module MaintenanceHot Swapping the Power Sub-Module Disconnecting the battery sub-module 86-87050-00 A01 Technical specifications Appendix MGE Standard Single Phrase Warranty Technical Support and Product Services Pulsar MX Glossary Pulsar MX Page Contact MGE Scenic Avenue, Costa Mesa, California 92626 714