Microsoft ES4625, ES4649 manual Renumbering the Stack

3 Configuring the Switch

CLI – Enter the IP address of at least one SMTP server, set the syslog severity level to trigger an email message, and specify the switch (source) and up to five recipient (destination) email addresses. Enable SMTP with the logging sendmail command to complete the configuration. Use the show logging sendmail command to display the current SMTP configuration.

Console(config)#logging sendmail host 192.168.1.4			4-50
Console(config)#logging sendmail level 3			4-50
Console(config)#logging sendmail source-email
big-wheels@matel.com			4-51
Console(config)#logging sendmail destination-email
chris@matel.com			4-51
Console(config)#logging sendmail			4-52
Console(config)#exit
Console#show logging sendmail			4-52
SMTP	servers
-----------------------------------------------
1.	192.168.1.4
SMTP	minimum severity level: 4
SMTP	destination email addresses
-----------------------------------------------
1.	chris@matel.com
SMTP	source email address: big-wheels@matel.com
SMTP	status:	Enabled

Console#

Renumbering the Stack

If the units are no longer numbered sequentially after several topology changes or failures, you can reset the unit numbers using the “Renumbering” command. Just remember to save the new configuration settings to a startup configuration file prior to powering off the stack Master.

Command Usage

•The startup configuration file maps configuration settings to each switch in the stack based on the unit identification number. You should therefore remember to save the current configuration after renumbering the stack.

•For a line topology, the stack is numbered from top to bottom, with the first unit in the stack designated at unit 1. For a ring topology, the Master unit taken as the top of the stack and is numbered as unit 1, and all other units are numbered sequentially down through the ring.

Web – Click System, Renumbering.

Figure 3-21 Renumbering the Stack

3-34