Washing and drying environmentally | Miele wt945, WT 945 S WPS

Washing and drying environmentally

–Ideally load the maximum amount specified for the programme you are using.

This way energy and water consumption will be kept to a minimum.

–Use the QUICK WASH programme for small loads.

–Use the Short wash option for lightly soiled laundry.

–A main wash (programme without pre-wash) is sufficient for cleaning normally soiled laundry.

–Use the Soak option for heavily soiled laundry. The wash temperature can be reduced for the main wash when using the additonal soak option.

–Use the additional option Soak instead of Pre-washwith heavily soiled laundry. If Soak is followed im- mediately by a main wash the same suds are used.

–Do not exceed the amounts of detergent which may be recommended by the manufacturer on the packaging.

–Reduce the amount of detergent with smaller loads (approx. 1/3 less than the amount recommended can be used when washing a half load).

–Load recognition can cause the duration of a programme to vary greatly. The main wash may be shortened and a rinse cycle omitted depending on the amount of laundry.

–Select a high spin speed for the wash programme, as well as for the Thermospin, if tumble drying the laundry afterwards. This saves time and energy.

12

Image 12

Miele wt945, WT 945 S WPS operating instructions Washing and drying environmentally

Contents

Operating instructions Washer-dryer WT 945 S WPS Contents Contents Consumption data Technical data Caring for the environment Disposal of the packing materialDisposal of your old appliance or machine Technical safety Correct usage Use Using accessories Disposal of your old machine Features Description of the appliance Control panel Start buttonDoor button Opens the drum door On / 0-OFF button Additional option buttons Important control panel features Spin button with indicator lampsProgramme selector Washing and drying environmentally Before using for the first time Flushing out the drumWater hardness reminder Programme overview Cottons eMinimum Iron e f Delicates f Woollens gQuick wash Starch Drain / SpinSeparate rinse Flushing out the drum How to wash correctly How to wash correctly Important other care symbolsTumble dry Ironing Separate washing Before washingSort the laundry Select a programme Detergent dispensing when selecting the soak option SoakPre-wash Water plus Adding detergent At the end of a programme Adding and removing laundry Door cannot be opened, if Programme cycle Cottons Special features in the programme sequences Quick Wash Adding detergent DetergentWater softener Washing with several components Fabric conditioners / starch formulations Fabric conditioners, texturisers and starchAdding fabric conditioner or liquid starch separately Separate starching Tips on drying Following fabrics should not be tumble dried Programme overview Timed Drying 20 min / 30 min / 40 min / 60 min Always select the Drying / Low temp. option Separate drying Before dryingPreparing the laundry Programme selection Select a drying programmeDrying / Low temp After drying Washing and drying in a continuous sequence Close the drum door Open the stopcock Add detergentSelect the programme After each washing or drying programme Rinse out fluff programme To cancel a programme To cancel an incorrectly selected programmeChanging a programme sequence To change a programme which has been locked Safety lock Safety lockEngaging the safety lock Cleaning and care Cleaning the machineCleaning the detergent dispenser Cloth Clean the porthole glass Clean the siphon tube Cleaning the filter in the water inlet Problem solving guide What to do if ... ? Programme does not start Dept Wash programme stops and a fault indicator light comes on Indicator lamp flashes Locked indicator lampDuring a programme But the wash General problems or an unsatisfactory wash or drying result Option Opened during or afterDrying Problem Possible cause Remedy Laundry is still When washingWhen drying separately Damp after a drying Problem Possible cause Remedy Laundry is not Spun satisfactorilyMachine is not Steady during a spin Problem Possible cause Remedy There is an excessive Build-up of foamWhite residues which Look like powder Problem Possible cause Remedy Liquid detergent does Not give the requiredResult Remember to remove Blocked drain outlet Opening the drum door After sales service Appliance guarantee Installation and connection Front view Installation surface InstallationPlease note the following Removing the transit fitting Screwing out and adjusting the feet Levelling the machine Installation and connection Electronic unit and washing machine housing Miele Waterproof systemInlet hose Drain hose Connection to the water supply Installation and connection Maintenance and care Connection to the drainage system Drain hose connection Non-rewireable plugs BS Electrical connection U.K Consumption data Programmes Technical data Programmable functions for changing standard settings Programmable functions High water level Additional rinse for Cottons programme Buzzer Opening the door at high temperatures Factory setting Final residual moisture after dryingShortening the drying time Lengthening the drying timePage Alteration rights reserved / 3404 / WT 945 S