. A complete Parts List is available at www.MillerWelds.com
5-2. Engine Prestart Checks
Full
Empty
| Check all fluids daily. Engine must be | |
| cold and on a level surface. Unit is | |
| shipped with 10W30 engine oil. | |
| . Follow | |
| manual. | |
| . This unit has a low oil pressure | |
| shutdown switch. However, some | |
| conditions may cause engine | |
| damage before the engine shuts | |
| down. Check oil level often and do | |
| not use the oil pressure shutdown | |
| system to monitor oil level. | |
| Fuel | |
| Add fresh fuel before starting engine | |
| the first time (see maintenance label for | |
| specifications). Always leave filler | |
| neck empty to allow room for expan- | |
| sion. Check fuel level on a cold engine | |
| before use each day. | |
| To check fuel level, turn Engine Control | |
| switch to either Run/Idle position. | |
| LED’s indicate fuel level in tank. | |
| Oil | |
| . Do not exceed the ”Full” mark on | |
| the oil level dipstick. The fuel | |
| pump may operate erratically if | |
| crankcase is overfilled. | |
| Check oil with unit on level surface. If | |
| oil is not up to full mark on dipstick, add | |
| oil (see maintenance label). | |
Full | Use front panel meters to determine | |
| hours until next recommended oil | |
| change (see Section | |
| . To improve cold weather starting: | |
| Keep battery in good condition. | |
| Store battery in warm area. | |
Full | Use correct grade oil for cold | |
weather. | ||
|
Gasoline
803 983−A / Ref 216
