- 35 -
• On Battery Shutdown The amount of time in seconds, after the event occurs, before the Remote Client will be
shutdown. If the event is removed before the delay time is reached, the action will be
cancelled. (See UPS and/or Operating System Shutdown on page 20)
• Low Battery Shutdown The amount of time in seconds, after the event occurs, before the Remote Client will be
shutdown. (See UPS and/or Operating System Shutdown on page 20)
NOTE: All Remote clients need to be configured to shutdown before the SentryII Server.
Starting SentryII Services From the Novell server, start SentryII Remote by entering the following commands at the console prompt: (NOTE: replace
InstallFolder with the folder name entered in step 4)
LOAD SYS:InstallFolder\SIIREMOTE\S2REMOTE.NLM
The SentryII Remote client should now be executing on the Novell Netware server. Within a few minutes, you should see the
following messages on the SentryII display:
Connecting to Server...
Successfully connected.
SentryII Remote is now running.
Step 1. You must be logged in to the server as root to ensure that you have full read and write privileges.
• Auto Install: Insert the SentryII Installation CD into the drive. Mount the CD-ROM drive. Execute the install script located
in the \RemoteClient\Unix folder on the SentryII Installation CD.
KNOWN ISSUE: The KDE desktop environment running with the Konqueror web browser does NOT work properly with install
scripts. For this setup, please use the Manual Install listed below.
• Manual Install: Insert the SentryII Installation CD into the drive. Mount the CD-ROM drive. Open a terminal windows and
go to the mnt/cdrom/RemoteClient/Unix folder. Type ./install at the command prompt to begin the install process.
Step 2. The install script will begin.
Step 3. All default install locations are recommended.