Mitsubishi Electronics HC7800DW user manual Viewing 3D images, Installing the 3D emitter

Viewing 3D images

With the separately sold 3D glasses (EY-3DGS-78U), you can enjoy viewing 3D images on this projector. To view 3D images, install the supplied 3D emitter.

Installing the 3D emitter

1.Unplug the power cord of the projector.

2.Place the supplied non-slip sheet on the bottom of the 3D emitter.

Non-slip sheet

3D emitter

3.Connect the 3D emitter terminal on the 3D emitter to the 3D SYNC terminal on the projector using the supplied mini DIN 5-pin cable.

Important:

•Do not put any object which obstructs the communication between the 3D emitter and the 3D glasses.

•Do not place the 3D emitter near the remote control sensor of other devices.

•The transmission distance is decreased when the infra-red signal from the 3D emitter is transmitted to the 3D glasses by reflecting on the screen. In addition, the transmission distance in such case varies depending on the characteristics of the screen.

To 3D emitter	To 3D SYNC
terminal	terminal

Mini DIN 5-pin cable

4.Plug the power cord of the projector into the wall outlet and turn on the power.

•The indicator on the 3D emitter will light green and the 3D emitter will be ready to communicate with the 3D glasses.

5.Adjust the position and angle of the 3D emitter so that the 3D glasses can receive the infra-red signal.

•The traveling distance of the infra-red signal from the 3D emitter is about 10 m in straight line from the front of the infra-red transmission part.

•You can adjust the angle of the infra-red transmission part as shown below. Loosen the knob to adjust the angle and after finishing the adjustment, tighten the knob.

Infra-red transmission part

Knob

•Secure the 3D emitter using the supplied 3D emitter securing screws as necessary.

EN-25