Viewing computer images
A. Connecting the projector to a computer
Preparation:
• Make sure that the power of the projector and that of the computer are turned off.
• When connecting the projector to a desktop computer, disconnect the computer cables that are connected to the
monitor. | 1. | Connect one end of the supplied computer cable to the | |
| |||
|
| COMPUTER/COMPONENT VIDEO IN terminal of the | |
To COMPUTER/ |
| projector. | |
COMPONENT VIDEO IN | 2. | Connect the other end of the computer cable to the | |
terminal | |||
| monitor port of the computer. | ||
|
|
2 
To monitor port
1
Computer cable
•Turn on the power of the projector before that of the computer.
•Additional devices, such as a conversion connector and an analog RGB output adapter, are required depending on the type of the computer to be connected.
•Use of a long cable may decrease the quality of projected images.
•Also read the instruction manual of the equipment to be connected.
•Images may not be projected correctly, depending on the type of the computer connected.
•Contact your dealer for details of connection.
About DDC
The COMPUTER/COMPONENT VIDEO IN terminal of this projector complies with the DDC1/2B standard and the HDMI 1 and HDMI 2 terminals comply with the DDC2B standard. When a computer supporting this standard is connected to this terminal, the computer will automatically load the information from this projector and prepare for output of appropriate images.
•After connecting a computer supporting this standard to this terminal, plug the power cord of the projector in the wall outlet first, and then boot up the computer.
B. Plugging the power cord
Plug the power cord in the same way as described in “Viewing video images.” (See page 17.)
