Indicators
This projector has two indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer.
POWER indicator 
STATUS indicator
Normal condition
POWER STATUS | CONDITION | NOTE | |
| Off |
| |
|
|
| |
Steady |
| Lamp | The power cannot be turned on by pressing |
red | Blinking | ||
|
| the POWER button. | |
| green |
| |
|
|
| |
| Blinking | Lamp | The power cannot be turned off by pressing |
|
| the POWER button. | |
| green |
| |
|
|
| |
Steady |
| The power is on. (Normal condition) |
|
green | Steady |
| |
|
|
| |
| green |
|
|
Abnormal condition
POWER | STATUS | CONDITION | POSSIBLE SOLUTION | |
Steady |
| Abnormal temperature |
| |
| • The vents are clogged with dust or dirt. | • Clean the vents. | ||
green |
| |||
| • The room temperature is high. | • Relocate the projector to a cooler place. | ||
or | Blinking orange | |||
|
|
| ||
Steady |
|
|
| |
red |
|
|
| |
|
| The protection circuit is working or the lamp is in an | • Wait until the STATUS indicator goes out, | |
Steady |
| abnormal condition. | then press the POWER button. | |
Blinking green |
| • If the above solution is not effective, | ||
red |
| |||
|
|
| ||
|
|
| replace the lamp. | |
|
| The lamp operation time exceeds the time elapsed | Replace the lamp. | |
Steady | Blinking green/red | until the | Change with a new lamp if this problem | |
green | (See page 42.) | recurs. | ||
| ||||
|
| |||
|
| The lamp operation time exceeds the time elapsed |
| |
| Blinking red | until the |
| |
| (See page 42.) |
| ||
Steady |
|
| ||
|
|
| ||
red |
| The lamp operation time exceeds the time elapsed |
| |
|
|
| ||
| Steady red | until the |
| |
| Off | The lamp cover isn’t closed. | Close the cover correctly. | |
|
|
| ||
Blinking | Steady | Abnormal. | Contact your dealer. | |
|
| |||
green/red |
|
| ||
or |
|
| ||
|
|
| ||
| Blinking |
|
|
