Timer Recording

Canceling a timer recording before the recording starts

1Press MENU on the remote control. Your VCR will turn on and VCR Main Menu will appear on your screen. Use the ADJUST buttons on the remote control to select Program to record. Press ENTER.

2Recap screen will display for 4 seconds. While this screen is displayed, press the ADJUST buttons to place the cursor next to the program you wish to cancel.

3Press CANCEL. The program is erased.

4Press MENU twice to turn off the menus.

Using a satellite receiver

If you are using a Panasonic, RCA, Sony,Toshiba, or Hughes satellite receiver, your VCR will turn the receiver on when a timer recording begins and off when the recording ends.

However, if you are using a PRIMESTAR® or DISH Networkreceiver, you will have to turn the receiver on before a timer recording begins.

Before turning off theVCR, to put your VCR in stand-by for recording, make sure that your satellite receiver’s menu turns off.

You can watch satellite channels through your VCR even when the VCR is turned off but only if you connected your VCR and TV with an S-Video cable and the Rear S-through in the S-VHSSet-Up menu is set to ON. If you used a standard video cable, you can only view satellite channels through your VCR when the VCR is on.

TIMER RESET

You can use TIMER RESET on the rear panel to erase both the clock and all timer recordings.

To use TIMER RESET, press it with a pencil or a ball point pen. The power will turn off and the clock will be cleared. All timer recordings are erased.

If you have set the Clock set setting of the Set the clock menu to AUTO, the auto clock function will automatically set the clock again.

Memory backup

If the VCR is without power for 30 minutes or less, it will retain the clock and the programmed settings. The VCR must have been plugged in for at least an hour beforehand to charge this backup. If the power is lost for more than 30 minutes, the time and the programmed settings will be lost.

If you have set the Clock set setting of the Set the clock menu to AUTO, the auto clock function will automatically set the clock again when power is restored.

Recap screen

ÂProgram to record￿

CH DAY

ON

OFF￿

¤2 MO11 11:30a 1:30pSP￿

----- --:-- --:-- SP￿

----- --:-- --:-- SP￿

----- --:-- --:-- SP￿ º¹MENU to go back￿

¹¹ADJUST to select￿ ²´³¹ENTER to enter￿ · ¹¹ADJUST to select￿

￿

VCR Rear Panel

TIMER RESET

TIMER RESET

35

Page 37
Image 37
Mitsubishi Electronics HS-U778 manual Canceling a timer recording before the recording starts, Using a satellite receiver