Advanced Features

Advanced Options

Using the remote control to operate your TV

The HS-U778 remote control can operate many of the frequently-used functions of your TV. You only need one remote to operate both your VCR and TV.

The HS-U778 remote control is pre-set to operate Mitsubishi televisions, but it can also operate TVs from other manufacturers. To set your remote control for your particular brand of television, follow these instructions.

setting up your remote control to operate your TV

1Turn off your TV.

2On the HS-U778 remote control, set the VCR/TV slide switch to TV position.

3While holding in SP/EP, press the brand code button listed that corresponds to the brand of your TV.

4Press TV POWER on the HS-U778 remote control. Once your TV has turned on, your remote is set up to operate your brand of TV.

If your TV does not turn on, repeat step 3 using the next code listed for the brand of your TV.

If none of the codes listed for the brand of your TV work, then repeat step 3 several times, using a different code button until one works. The possible code buttons are: 0, 1-9, MUTE,VOLUME »,¼, CHANNEL»,¼ and INPUT.

You do not need to perform this set-up again until you change the batteries, set up your remote for another brand of television, or you get a new TV.

Once you have correctly set your remote control to operate your TV, you will be able to use the TV POWER, CHANNEL,VOLUME, and number buttons to operate your TV.

IMPORTANT

Because of variations among models, some or all buttons may not work, or they may operate different functions than expected for your particular TV. If this occurs, you may need to use your TV remote control.

Sometimes manufacturers will change the remote control codes for their products, or they will use more than one code. If this is the case, your remote may not be able to control your TV.

When you replace the batteries in your remote, the remote may return to its initial setting (code button 1). Repeat the steps above to reset your remote control. If you enter a new code, the previous code will be erased.

operating your TV with the HS-U778 remote control

1Set the VCR/TV slide switch to TV position on the HS-U778 remote control to tell the remote that you want to operate the TV.

2Point the remote control towards the TV and press the desired buttons. To once again control theVCR, set the VCR/TV slide switch to VCR position.

Brand of TV

Brand code

 

buttons

Mitsubishi

1, 2, 3

Fisher

0

G.E.

VOLUME »

Goldstar

2, 9

Hitachi

8

JVC

MUTE

Magnavox

4

NEC

2, 9

Panasonic

CHANNEL»,¼

Pioneer

6

Philips

4

Proscan

VOLUME »

Quasar

CHANNEL¼

RCA

VOLUME» ￿

Sanyo

0

Sharp

3, 5

Sony

VOLUME¼

Toshiba

7

Zenith

INPUT

1 2 3

4 5 6

7 8 9

0 X2

VCR

TV

52

Page 54
Image 54
Mitsubishi Electronics HS-U778 manual Advanced Options, Using the remote control to operate your TV