Mitsubishi Electronics PD-5030, PD-6130 manual Rear View/ Terminal Board, EXT Speaker L and R

Rear View/ Terminal Board

C	3VIDEO	)	VIDEO 1	VIDEO 2VIDEO
		(
		IN/OUT
	)	L	1AUDIO R		D
	(
	MONO
		Y
E		Cb/Pb		DVD1 / HD
		Cr/Pr		1
	)	L	2AUDIO R
	(
	MONO
		Cr/Pr	R/
F		G/ Y		RGB2
		Cb/Pb	B/	/ DVD2
				/ HD
		HD		2
		VD
G		(IN / OUT)		RGB 1
	)	L	3AUDIO R
	(
	MONO
H		DV I ( Digital RGB		MONITORLINK
		)
I		MONITORLINK CONTROL
J		IN
		REMOTE
K		OUT

AAC IN

Connect the included power cord here.

BEXT SPEAKER L and R

Connect speakers (optional) here. Maintain the correct polarity. Connect the (positive) speaker wire to the

EXT SPEAKER terminal and the (negative) speaker wire to theEXT SPEAKER terminal on both LEFT and RIGHT channels.

Please refer to your speaker’s owner’s manual.

CVIDEO1, 2, 3 (BNC, RCA, S-Video)

Connect VCR’s, DVD’s or Video Cameras, etc. here. VIDEO1 can be used for Input or Output (see page 10).

DAUDIO1, AUDIO2, AUDIO3 These are audio input terminals.

The input is selectable. Select the individual video setting from the audio menu screen.

EDVD1 / HD1

Connect DVD’s, High Definition or Laser Discs, etc. here.

FRGB2/ DVD2/ HD2

RGB2:	You can connect an analog RGB signal
	and the syncronization signal.

DVD2/ HD2: You can connect DVDs, High Definition sources, Laser Discs, etc. here.

This input can be set for use with an RGB or component source. (see page 22)

GRGB1 (mini D-Sub 15pin)

Connect an analog RGB signal from a computer, etc. here. This input can be used for Input or Output. (see page 10)

A B

HMONITORLINK™ / DVI (Digital RGB) MonitorLink when used with MonitorLink Control is a Mitsubishi exclusive proprietary digital interface for the display of high quality digital video signals from a Mitsubishi HD Receiver/Controller, such as the HD-5000.

The MonitorLink input can also be used as a DVI input from other sources. The left and right audio allow the external Mitsubishi HDTV Receiver/Controller or DVI set-top box to provide audio to the TV to be able to use the TV speakers. When MonitorLink is used as DVI, it is HDCP compatible.

Note: When MonitorLink is used as a DVI-HD input, the terminal is compliant with EIA-861 standards for extended and high definition video, however, this input is not intended for use with personal computers or devices outputting video signals with computer resolution.

IMONITORLINK™ CONTROL / RS-232C

A digital control interface that works in conjunction with MonitorLink. While MonitorLink provides the digital video signal, MonitorLink Control provides enhanced functioning such as automatic power ON/OFF and input selection. If you are not connecting a Mitsubishi HDTV Receiver/Controller with MonitorLink features, MonitorLink Control can be used as an RS-232C control signal input port with an external control system. Please visit www.mitsubishi-tv.com for RS-232 command protocol.

JREMOTE IN

Connect the remote cable to the remote control’s remote jack to obtain wired remote control.

KREMOTE OUT

Connect the remote cable to the REMOTE IN jack of the other display monitor to obtain wired remote control.

3