Using the wired remote control mode
Connect one end of the remote cable to the remote control’s REMOTE JACK and the other end to the “REMOTE IN” terminal on the monitor. When the cable is connected, the mode automatically switches to wired remote control. When the wired remote control mode is used, the remote control can be operated even if no batteries are installed.
Operating Range
*Use the remote control within a distance of about 7 m/ 23ft. from the front of the monitor’s remote control sensor and at horizontal and vertical angles of up to approximately 30°.
*The remote control operation may not function if the monitor’s remote control sensor is exposed to direct sunlight or strong artificial light, or if there is an obstacle between the sensor and the remote control.
( |
| AUDIO2 R | |
MONO |
| ||
) | L | ||
| Cr/Pr | R/ |
|
| G/ Y | RGB | |
| Cb/Pb | B/ | 2 / DVD2 |
| HD |
| / HD2 |
| VD |
|
|
| (IN / OUT |
| RGB 1 |
| ) |
|
|
( |
| AUDIO 3 R | |
MONO |
| ||
) | L | ||
| DV I ( Digital RGB |
| MONITORLINK |
| ) |
|
|
| Monitorlink Control |
|
|
| IN |
|
|
| REMOTE |
|
|
| OUT |
|
|
MONITORLINK CONTROL |
IN |
REMOTE |
OUT |
Remote Control
Cable
Approx.
7m/23ft
To Remote Jack
Handling the remote control
•Do not drop or mishandle the remote control.
•Do not get the remote control wet. If the remote control gets wet, wipe it dry immediately.
•Avoid heat and humidity.
•When using the remote control in the wireless condition, be sure to unplug the remote cable from the REMOTE IN terminal on the monitor.
•Do not mix new and old batteries.
•Do not heat, take apart, or throw batteries into a fire.
•When the remote control is not being used for a long period of time, remove the batteries.
6
