Mitsumi electronic HD8000 Bottom side, Remote control, Preparating your projector continued

Preparating your projector (continued)

Bottom side

1

2

3

1Adjustment feet

2Air inlet grille/Filter cover

3Lamp cover

Caution:

Do not replace the lamp immediately after using the projector because the lamp would be extremely hot and it may cause burns.

Remote control					1	Laser aperture
1					2	Transmission window
					3	Wired remote control jack
					4	Indicator
2				3	5	POWER button
					6	VIDEO button
					7	DVI-D(HDCP) button
4					8	HOME button
					9	END button
5					10 Page Up and Page Down buttons
					11	Mouse pointer
				17
6		COMPUTER			12	LENS SHIFT button
		1	2
7	DVI-D(HDCP)	VIDEO	S-VIDEO	18	13 MENU button
8	HOME	Page Up	AUTO POSITION	19	14 ZOOM/FOCUS button
9	END	Page Down	LASER	20	15	+ , - (VOLUME) buttons
					16 COLOR ENHANCER (CE) button
10
					17 COMPUTER 1, 2 buttons
29					18	S-VIDEO button
11				21
					19 AUTO POSITION button
12					20 LASER button
				22	21	S, T, W, X buttons
13	MENU	R-CLICK	ENTER	23	22	R-CLICK button
14	VOLUME		ASPECT	24	23 ENTER button
	ZOOM / FOCUS LENS SHIFT KEYSTONE
15			SPLIT	25	24 KEYSTONE button
				26	25 ASPECT button
					26	SPLIT button
16	CE	AV MUTE	FREEZE	27
					27 FREEZE button
				28
					28 AV MUTE button
					29	Left click button
					•	Pressing the LASER button emits a laser beam.
						Even when you keep holding down the LASER but-
						ton, it is emitted only one minute. To keep emitting
						it longer, press the LASER button again.
					•	You can disable the LASER button to prevent laser
						radiation due to misuse of the button.
						How to disable the LASER button
or						While holding the LASER button down, press the T
						button 3 times.
						How to enable the LASER button
						While holding the LASER button down, press the S
There are 2 types of labels placed on the back of the						button 3 times.
						• Whenever the batteries are replaced, the LASER
remote control and either of them is placed on it.						button is enabled.

About the laser beam

This remote control is a Class 2 laser product. (Max. output: 1 mW, Wavelength: 620-640 nm)

Beam Divergence: 6 m distance about 10.0 mm x 10.0 mm (±6.0 mm)

Caution:

•Pressing the LASER button on the remote control emits a laser beam. Do not look into the laser beam directly. Do not point the laser beam at anyone. Looking at the laser beam directly may damage eyesight.

•Use of controls or adjustments or procedures other than those specified herein may result in hazardous radiation exposure.

•This remote controller cannot be repaired.

EN-8