cleaning and maintenance | LX Series Direct Vent Gas Fireplace |
|
|
WARNING | Turn off gas before servicing fireplace. It | |
is recommended that a qualified service | ||
| ||
| technician perform these | |
| beginning of each heating season | |
|
|
Make sure the gas valve knob is in the “OFF” position. Wait at least five (5) minutes before
Venting system
A qualified agency should examine the venting system annually.
Cleaning glass
Clean the ceramic glass periodically. Condensation will sometimes form on the glass during a cold startup. This is normal for all gas fireplaces. This condensation often attracts dust and lint to the surface of the glass. The initial paint curing of the appliance can also leave a slight film on the glass.
Your should clean the glass after the first two weeks of use. After that, you should clean the glass no more than two or three times a season. Use a mild glass cleaner to clean the door.
Do not use abrasive cleaners. They will damage the glass surface.
PILOT AND BURNER FLAMES
Visually check pilot and burner flames periodically. Refer to Figure 54 for typical burner flame. Refer to Figure 55 for typical pilot flame.
FIREBOX CLEANING
1.Carefully remove log set, and embers from combustion chamber.
2.Vacuum burner compartment thoroughly.
3.Vacuum any dust off logs.
4.Remove any lint from main burner and pilot.
5.Carefully replace log set, and embers in their correct positions. Page 28
6.Replace door (if it has been removed).
7.Relight pilot. Page 35
8.Turn on main burner.
| WARNING | Carefully reassemble and reseal fireplace |
|
| |
|
| properly after any cleaning or servicing. |
|
|
|
| CAUTION | Allow glass to cool before cleaning. Do |
|
| |
|
| not clean glass when it is hot. Damage |
|
| could occur. |
|
|
|
| WARNING | Make sure clearances to combus- |
|
| |
|
| tibles allow room for maintenance |
|
| and service. |
|
|
|
Thermocouple
Thermopile
Figure 54 - | FP2721 | |
Typical Pilot Flame | ||
|
Figure 55 -
Typical Burner Flame
Appearance
LG812
51D0528 | 37 |