SS38 Direct Vent Gas Stove | STOVE INSTALLATION |
1.Check gas type. The gas supply must be the same as stated on the appliance’s rating decal. If the gas supply is different from the stove, STOP! Do not install the appliance. Contact your dealer immediately.
2. To ease installation, a 30" (mm) flex line with manual
3. After completing gas line connection, purge air |
|
| |
from gas line and test all gas joints from the gas |
|
| |
meter to the stove for leaks. Use a soap and water |
|
| |
solution or a gas sniffer. | Pressure |
| |
|
| ||
4. To adjust flame height, turn HI/LO knob to HI to get | Test “IN” |
| |
maximum pressure to burner. Turn HI/LO knob to |
|
| |
LO to get minimum pressure. | Pressure | FP1979 | |
5. To check gas pressures at valve, turn captured | Test “OUT” | ||
| |||
screw counter clockwise 2 or 3 turns and then place | HI/LO Knob |
| |
tubing to pressure gauge over test point. Turn unit |
| ||
Pilot Adjustment Screw | |||
to high. Figure 29. After taking pressure reading, | |||
be sure and turn captured screw clockwise firmly |
| Figure 29 - | |
to reseal. Do not over torque. Check test points for |
| Gas Pressure Check at Gas Valve | |
gas leaks with a soap and water solution. |
|
| |
WARNING
INSTALLING LOUVERS
Do not use open flame to check for gas leaks.
Attach the top louver unit (two louvers and two louver brackets) to stove with four (4) screws provided — two (2) on each side. Figure 30. Repeat for bottom louver unit.
Louver Bracket
Louver
Bracket 
Louvers Screws
Figure 30 - Installing Louvers
ST1113
22 | 46D0232 |
