SS38 Direct Vent Gas Stove | FINAL INSTALLATION |
Before you begin — This unit is supplied with six ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
WARNING
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance. Never add additional logs or embellishments such as pine cones or vermiculite to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts specifically approved for this heater may result in property damage or personal injury.
Installing logs and rock wool (ember material) in firebox
Rear Log
1. Carefully remove logs from wrapping.
2. Open front door of firebox.
3. Place rear log against back of firebox. Figure 32
| Figure 32 - |
LG735 | Install Rear Log |
Left Base Log
4. Place left base log on two pins against left side of firebox. Figure 33
Figure 33 -
Install Left Base Log
LG736
24 | 46D0232 |
