Monessen Hearth WDV500 signature command - Optional fan blower system, A/C Wiring to junction box

signature command - Optional fan blower system WDV Series Gas Fireplace

A/C Wiring to junction box

important: Always check local building codes. This installation must comply with local regulations as well as the National Electric Code.

WIRING

1.Before installing the blower, wire the receptacle into an electrical circuit. This should be done before framing the fireplace. Wire with minimum 60° C wire in accordance with prevailing codes.

2.Remove the external junction box cover by removing the screw from the right side of the outside firebox wall. Junction box was installed at the factory.

3.The junction box cover has a factory installed “romex” style strain relief connector. After connecting the wires, route the wire leads through this connector. Refer to the wiring diagram in Figure 33.

			120V AC
			60Hz
			Factory Supplied
			Not Supplied
	Junction Box
		Figure 33 -
		Junction Box Wiring Diagram
RNGNI	Before installing the blower, turn off the fireplace and
	allow to cool. Only a qualified service person should
	service and repair the fireplace. A qualified service
AW	person should connect and disconnect the fireplace
	to gas supply. Follow all local codes.

Optional Fan/Blower System (BLOTBLDVSC)

Black

	To Junction Box		AC Module
	In Fireplace
Blower		Light {
Right			White
	White		Black
Black	Black	AUX {	Black
			White
Blower			Green
Left			Connector
			Pin To Control Box
Figure 34 -			Control Box
Blower Wiring Diagram
			FP1915

AW RNI GN

Electrical Grounding Instructions: This appli- ance is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three prong receptacle.

78D0011 25