WDV Series Gas Fireplace | SIGNATURE COMMAND SYSTEM OPERATION INSTRUCTIONS | ||
FEATURES |
|
|
|
Command Center |
| RF Receiver | To Thermopile |
|
| ||
• Easy Access Function Operation and System Configura- | ON/OFF | To Sensor | |
| |||
|
| ||
tion |
|
| To Sparker |
• Operation Confirmation/Fault Diagnostic Indications (LED/ | NG/LP |
| |
Buzzer) |
| Conversion |
|
• ON/OFF/HI/Low Operation |
|
| |
|
|
|
Control Board
• Electronic Ignition |
• Pilot Lockout safety feature |
• Electric Power Regeneration from Thermopile to save bat- |
tery |
• |
• Convenient NG/LP Gas Type Conversion |
• Standing Pilot/Intermittent pilot Conversion |
• Previous settings Restoration Ability |
• Uninterrupted Operation During Power Outage (Automatic |
Control
Board
Command Center
To Command
Center
To Stepper Motor
To Valve
Battery Door
AC Module
| Battery Backup) |
• | ON/OFF RF Remote Receiver |
• | Optional Transmitter Learn Capability |
AC Module
•Easy
•Embedded Compact 120 V AC Adapter with Auto Battery Back up Feature
•Remote Controlled Blower, Lighting, and Auxiliary AC Outputs
Transmitter | RFSC |
Three Flame Height Settings | X |
Low battery Indication for Transmitter | X |
Child Proof | X |
LCD Backlight | X |
Security Codes | X |
Thermostatic Control Mode | X |
Three Brightness Settings for Lights | X |
Three Speed Control for Blower | X |
On/Off AUX Control | X |
Programmable Timer to turn blower on and off | X |
Master Switch
ON
LED
OFF
Figure 38 - Signature Command System Components
BATTERY INSTALLATION
The Command Center uses four (4) "AA" batteries.
To Install Batteries:
1.Press down the battery door tabs and pull out to remove battery door.
2.Install the batteries as indicated on Command Center.
3.Close battery door by snapping in place.
4.When the four (4) batteries are installed the system is ready for use.
5.The batteries should be replaced when the LED indicates low battery.
30 | 78D0011 |