Remote Control Operation, WDV Series Gas Fireplace

REMOTE CONTROL OPERATION	WDV Series Gas Fireplace
REMOTE TRANSMITTER OPERATIONS
General	°F
General

Figure 39

The RFSC Remote Control has two (2) operating modes: Manual and Thermostatic. The control system can be set to a temperature range between 45° F and 90° F. The blower speed, light, rear burner shut down and flame height can be adjusted in either the manual and thermostatic mode.

The transmitter will operate the remote receiver from 12" to a maximum of 30'. NOTE: The distance decreases when the batteries are low.

Initial Startup

Figure 40

▲ON	▲OFF
FAN	AUTO
LIGHT	AUX

AMBIENT	FP2141

Figure 39 -

Remote Transmitter

1.After initial power up or when RESET button is pressed, the transmitter is reset. The reset button is located behind the battery door of transmitter.

2.During system reset, all features of the LCD DISPLAY will be visible. After one second, the LCD will be initialized. A typical reset display is shown in Figure 49. Note that the temperature scale is degree F.

3.Press ON button to select between °C and °F display. It will exit setting mode automati- cally after 10 seconds if no key is pressed. The transmitter will send an OFF signal after reset.

4.After reset, the transmitter is operating in manual mode. The room temperature is shown.

Manual Mode

Figure 41

1.Press the ON button once to turn on the appliance with max flame height.

2.Press the OFF button to decrease flame height. The first two (2) presses will decrease flame height to lower level. The third press will turn off the fireplace.

3.If OFF button is held for more than three (3) seconds, the fireplace will be shut off and remembers the last flame height setting. It will also remember light and auxiliary settings. To reset, change setting and hold OFF button for 3 seconds. New setting is now remem- bered.

Thermostatic Mode

Figure 42

1.Press the AUTO button to enter the thermostatic mode.

2.In thermostatic mode, press the ON / ▲ button or OFF / ▼ button to set the desired set temperature.

3.Once the setting is completed, the transmitter will automatically turn on the fireplace when the room temperature is below the set temperature and turn off the fireplace when the room temperature is above the set temperature within 1 degree.

4.There will be a slight delay in the response of the unit (on/off) to a temperature. Room temperature is monitored every three (3) minutes.

5.Press AUTO button to exit the thermostatic mode. The transmitter will be in the manual off mode and the fireplace will be shut off.

NOTE: When thermostat mode is used, the command center ON/OFF buttons will not function, only the master switch will function.

°F