Signature command Optional Wall command center and blower system
PILOT
CAUT NIO
AW RNI GN
|
|
|
|
|
|
|
|
| TO JUNCTION BOX | ||||
|
| IN FIREPLACE | ||||
BLACK | WHITE | |||||
|
|
|
|
|
| |
Opt. Blower 
WHITEBLACK
Opt. Aux. BLACKWHITE
GREEN
Electrical connections should only be performed by a qualified, licensed electri- cian. Main power supply must be turned off before performing service.
Only a qualified service person should service and repair the fireplace. A quali- fied service person should connect and disconnect the fireplace to gas supply. Follow all local codes.
figure 32 -
Signature Command Wiring Diagram
A/C BOX
RF RECEIVER
ON/OFF BUTTON
CONTROL BOX
BLACK/THERMOPILE
RED/THERMOPILE
CONVERSION |
|
NG/LP | SENSING |
|
IGNITER/SPARKER
PLUG IN CONNECTOR
CONTROL BOX TO COMMAND CENTER
OFF/LO
MASTER
LED ON/HI SWTICH
| ||
| COMPARTMENT | |
PLUG IN CONNECTOR |
| |
STEPPER MOTOR TO | COMMAND | |
CONTROL BOX | ||
CENTER | ||
| ||
GROUND |
| |
DC POWER/GREEN |
| |
PLUG IN CONNECTOR |
| |
CONTROL BOX TO |
| |
SOLENOID |
| |
GAS IN | GAS OUT |
PILOT GAS TUBING
VALVE
COMMAND CENTER WALL INSTALLATION
The Command Center may be mounted on the wall with the use of the SCSWEK Kit. (15' cable, junction box and wall cover).
Mount the junction box provided at the desired location on the wall. Do not extend beyond the 15' wire cable provided.
Route wire from junction box to lower control area at bottom of fireplace. Unplug the 12' cable from control box and command center. Plug the 15' extension cable into the control box. Remove com- mand center from the fireplace and plug the other end of the extension cable into the command center. Snap on wall cover provided and screw to junction box.
24 | 78D0011 |
