3
32
The DSR-6000 displays warning messages for the following conditions:
• A warning message is displayed when the user changes from a MPEG program
number selection to a virtual channel.
Press any arrow button (3456) to back out of the field and leave it
unchanged. Otherwise, press the ENTER button to proceed.
• If the user selects a virtual channel that is not in the chosen VCT, then a
warning message, “Not in map” is displayed to the right of the virtual channel.
• Virtual channels identify satellite and polarity attributes. The RF input ports are
set up with satellite and polarity attributes. For more details, see "Port Menu"
on page 18. The DSR-6000 uses these satellite and polarity attributes to
determine which RF port to use. However, if the user selects a virtual channel
that does not match the satellite and polarity attributes of either port, then the
DSR-6000 is unable to determine which port to use and the following warning
message is displayed.
Press any arrow button (3456) to back out of the field and leave it unchanged.
Note: The DSR-6000 cannot decode the chosen virtual channel until a port is set
up with the applicable satellite and polarity information.
Xpndr Field
This non-editable field displays the current (Xpndr) transponder name (alpha/
numeric) that is downloaded. If the user selects a virtual channel that is not in the
chosen VCT, then a warning message, (Not in map) is displayed to the right of the
virtual channel. This field serves as a label or identifier for the signal source. For
more details, see "Port Menu" on page 18.
Press E to continue or to stop
CAUTION: Changing to DCII selection mode
E 00000 0000 (Not in m ap)
CHANNEL VCT Channel Xpndr
Press E to continue or to stop
CAUTION: Channel dddd not present