Motorola HT 1000 service manual Removal And Installation

level at the radio standard antenna port to 1mV (-47dBm) modulated with 3.0 kHz FM deviation of a 1 kHz tone.

	12.Use the UP/DOWN arrow keys to obtain a discriminator level
	between 206 - 218mVrms (target value of 212 mVrms) observed on
	the ac volt-meter.
	13.Press F8 to program the softpot value.
	14.Press F10 to return to the RECEIVER menu.
Removal And Installation	Refer to Appendix Figure 2, Secure Module Location Detail, when
	adding, removing, or replacing the secure module and/or secure
	module pad. Notice the orientation of the secure module and the
	secure module pad to the controller board.
Removal	Perform the disassembly procedure outlined in Section 6, up to and
	including removing the radio’s front shield. Remove the secure
	module by pulling it out and away from the controller board.
	NOTE: The secure module and the controller board
	connect via a plug and jack located at the
	opposite corner from the round popple switch.
	Remove the secure module pad as necessary.
Replacement/Installation	Perform the disassembly procedure described in the preceding
	paragraphs. Refer to Appendix Figure 2 for secure module pad and
	secure module board orientation. If the secure module pad was
	removed, place the removed pad or a new pad (Motorola part number
	7505670Z01) on the controller board and ensure that it seats flush
	with the controller board on all sides. Place the secure module on the
	secure module pad. Press the secure module plug into the controller
	board jack with enough force so that the jack and plug snap together.
	Reassemble the radio per the procedure outlined in Section 6 of this
	manual.

Appendix A- 8