Motorola HT 1000 service manual Model Charts Model Programming Flashing, and Cloning

Model Charts

Model Programming,

Flashing, and Cloning

Model Charts General Description

Four model charts cover the three families of radios discussed in this publication:

Conventional Systems Radios, HT 1000

Conventional Systems Radios, JT 1000 and MT 2000

Private Systems Radios

Shared Systems Radios

Each model chart lists the model number and its description, and the three main radio components: the transceiver board, the controller board, and the front cover. A single model may be built using alternate controller boards and alternate transceiver boards. The model charts will list all alternate controllers and all alternate transceivers for any one particular model. Other model components are referenced in electrical parts lists and exploded view parts lists located toward the rear of the manual.

To determine which controller and transceiver is in a radio, that radio must be opened and physically examined. Identification kit number labels are attached to the controller board and to the transceiver board.

Programming,

Flashing, and

Cloning

All HT 1000, JT 1000, MT 2000, MTS 2000, and MTX Series Radios covered in this manual are clonable. The JT 1000 Model Radios are also front-panel programmable, and the MTS 2000 Series Radios are “flashable.” The following cloning information applies only to HT 1000 Model Radios.

HT 1000 Model Radios:

VHF DN models cannot be cloned to AN, BN, or CN models.

Any DN model can be cloned from like CN or DN models.

Prior to cloning any AN or BN model into a like CN or DN model, a code plug fix must be performed on the AN or BN model. Failure to do so could seriously degrade the scan and battery-saver capabilities of the CN or DN model radio. For code plug-fix information, order Service Repair Notice, SRN-1218.

Note: Cloning any AN model into a like CN or DN model will remove the TEST MODE capability.

vii