Motorola Control Head Test Mode, HT 1000/JT 1000 Radios, Test Frequencies, HT 1000 / JT

Table 6 Test Frequencies, HT 1000 / JT 1000

NO. OF	TEST	VHF	UHF BAND 1	UHF BAND 2	800
BEEPS	CHANNEL
	TX #1	136.025	403.100	450.025	806.0125
1
	RX #1	136.075	403.150	450.075	851.0625
	TX #2	142.125	424.850	465.225	815.0125
2
	RX #2	142.175	424.900	465.275	860.0625
	TX #3	154.225	438.050	475.225	824.9875
3
	RX #3	154.275	438.100	475.275	869.9375
	TX #4	160.125	444.050	484.975	851.0125
4
	RX #4	160.175	444.100	485.025	851.0625
	TX #5	168.075	456.350	500.275	860.0125
5
	RX #5	168.125	456.400	500.325	860.0625
	TX #6	173.975	463.700	511.975	869.9875
6
	RX #6	173.925	463.650	511.925	869.9375

Control Head Test Mode, HT 1000/JT 1000 Radios

To check the buttons and the switches, perform the following tests:

1.Turn radio on.

2.After the self test is complete, press the monitor button (side button 3, SB3) five times in succession, within 10 seconds. After the fifth press, a tone is emitted to indicate that the RF test mode has been entered.

3.Exit the RF test mode and enter the control head test mode by pressing and holding SB3 for more than three seconds. Upon entering the control head test mode, a tone is emitted and the green LED begins flashing. The green LED continues to flash until the control head test mode is exited.

NOTE: Return to the RF test mode by pressing and holding SB3 for more than three seconds. Then re-enter the control head test mode by pressing and holding SB3 for more than three seconds.

4.Test each switch (toggle, rotary, or button-actuated) by changing the position of the switch. A tone is emitted to indicate a “good test” each time a switch position is changed.

NOTE: Pressing and releasing a button-actuated switch are both considered switch-position changes.

NOTE: No tone when a switch position is changed indicates a test failure. Test the on/off volume potentiometer/switch by rotating the potentiometer clockwise and counter

9