2
Hardware Installation
The installation of the Smartio C168 Series consists of hardware and software installation. The hardware installation is detailed in this chapter. The next chapter deals with the software installation for various operating systems.
JP1
Smartio C168 Series
Default Settings
The Smartio C168 Series has the following default (factory) settings:
I/O address: | 0x180 (Port 1), 0x188 (Port 2), 0x190 (Port 3), 0x198 (Port 4) |
| 0x1A0 (Port 5), 0x1A8 (Port 6), 0x1B0 (Port 7), 0x1B8 (Port 8) |
IRQ: | 10 |
INT Vector: | 0x1C0 |
CAP Jumper JP1: Open
Note ! If the default settings above are what you desire and good for the system without conflicts, you may simply install the board in the system and go directly to the next chapter, “Software Installation”. Otherwise, follow the instructions below.
Smartio C168H/HS User’s Manual
