Moxa Technologies C168HS user manual SCO Unix, # moxaadm

Software Installation

Please select one of the following OSs:

1.SCO UNIX

2.UNIX SVR4.2

Select :

Please select one of the devices where the driver diskette/files put:

1.	/dev/fd0135ds18	(A: 1.44MB	)
2.	/dev/fd096ds15	(A: 1.2 MB	)
3.	/dev/fd1135ds18	(B: 1.44MB	)
4.	/dev/fd196ds15	(B: 1.2 MB	)
5.	Hard Disk	/tmp/moxa

Select :

Then the MOXA Multiport Board Installation Utility will show for board installation.

Choose C168 Series driver and follow the instructions to install.

Step 6. Configure the board by,

#moxaadm

The moxaadm utility is used to tell the UNIX driver how many Smatio C168 Series boards are installed, what their basic setting (I/O or IRQ), etc. It is also used to remove the Smartio C168 Series UNIX driver from the system. Whenever the setting is changed, run this utility again and tell the UNIX driver what is changed. Refer to section “Administration Utility- moxaadm” for more information.

This utility is not intended to change the Smartio C168 Series “hardware” I/O address nor IRQ setting. If you need to change the Smartio C168 Series hardware IRQ, for example, you need to execute IO-IRQ utility under DOS environment. The IO-IRQ utility is contained in the Dos/Windows3.x driver diskette.

Only up to two Smartio C168 Series boards are allowed to be installed under UNIX systems when MOXA UNIX driver is used.

Smartio C168H/HS User’s Manual 3-25